Kia Niro: Lubrication System / Oil Cooler Repair procedures
| Removal |
| 1. |
Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") |
| 2. |
Drain the engine oil and then remove the oil filter. (Refer to Lubrication System - "Engine Oil") |
| 3. |
Drain the coolant. (Refer to Cooling System - "Coolant") |
| 4. |
Disconnect the coolant hose (A).
|
| 5. |
Unfasten the fixing bolt (A) and then remove the oil cooler assembly (B).
|
| Installation |
| 1. |
Apply engine oil to the oil cooler packing surface (A).
|
| 2. |
Install the oil cooler (A) with a fixing bolt (B).
|
| 3. |
Connect the coolant hose (A).
|
| 4. |
Fill the coolant. (Refer to Cooling System - "Coolant") |
| 5. |
Install the oil filter and then fill the engine oil. (Refer to Lubrication System - "Engine Oil") |
| 6. |
Install the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") |
Oil Pan Repair procedures
Removal
1.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.
Drain engi ...
Oil Pressure Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
(Refer to Engine and Transaxle As ...
Other information:
Kia Niro (DE HEV) Owners Manual: Operating conditions
The indicator on the switch will illuminate when the Blind spot detection system
switch is pressed with the ignition switch ON. If the vehicle speed exceeds 30 km/h
(18.6 mph), the system will activate.
If you press the switch again, the switch indicator and system will be turned
off.
If t ...
Kia Niro (DE HEV) Owners Manual: Light bulb position (Rear)
■ Rear combination lamp - Type A
■ Rear combination lamp - Type B
■ Back up lamp
■ License plate lamp
■ High mounted stop lamp
(1) Stop/tail lamp(Bulb type)
(2) Tail lamp(Bulb type)
(3) Rear fog lamp(LED type)
(4) Rear turn signal lamp
(5) Stop/tail lamp(LED type)
(6) B ...
