Kia Niro: Fuel Delivery System / Fuel Filter Repair procedures
| Removal |
| 1. |
Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") |
| 2. |
Disconnect the fuel pump motor connector (A) and fuel sender connector (B).
|
| 3. |
Lift the fixing hook (A) by using a common driver, and then remove the fuel sender (B).
|
| 4. |
Remove the fixing clip (A), and then disconnect the feed tube (B).
|
| 5. |
Remove the head assembly (B) after releasing the cushion fixing clip (A).
|
| 6. |
Remove the reservoir-cup (B) after releasing the fixing hook (A).
|
| 7. |
Disconnect the ground line (A). |
| 8. |
Disconnect the fuel pump motor connector (B).
|
| 9. |
Remove the fuel pressure regulator (B) after releasing the fixing hook (A).
|
| 10. |
Remove the pre-filter (B) after releasing the fixing hooks (A).
|
| 11. |
Remove the fuel pump motor (A) from the fuel filter by pulling it downward.
|
| 12. |
Remove the fuel filter after releasing the fixing hooks (A).
|
| Installtion |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Repair procedures
Inspection
[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) terminal.
2.
Remove the fuel pump assembly.
...
Fuel Pump Motor Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.
Disconnect the fuel pump motor connector (A) and f ...
Other information:
Kia Niro (DE HEV) Owners Manual: 3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls
exhaust emissions while maintaining good vehicle performance.
Vehicle modifications
This vehicle should not be modified. Modification of your vehicle could affect
its performance, safety or durability and may even ...
Kia Niro (DE HEV) Owners Manual: Storing positions into memory using the buttons on the door
Storing driver’s seat positions
1. Shift the shift lever into P while the engine start/stop button is ON or ignition
switch ON.
2. Adjust the driver’s seat and outside rearview mirror comfortable for the driver.
3. Press SET button on the control panel. The system will beep once.
4. Press ...
