Kia Niro: Tires/Wheels / Wheel Repair procedures
| Hub nut tightening sequence |
Tighten the hub nuts in the following sequence.
|
Tightening torque: 88.3 - 107.9 N·m (9.0 - 11.0 kgf·m, 65.1 - 79.6 lb·ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
Run out inspection
| 1. |
Jack up the vehicle. |
| 2. |
Measure the wheel run-out by using a dial indicator as shown below.
|
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Tire Repair procedures
Tire Wear
•
Using tires and wheel other than the recommended sizes could
cause unusual ...
Alignment Repair procedures
Front wheel alignment
When using a commercially available computerized wheel alignment equipment
to inspect the f ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Center Fascia Panel Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
Kia Niro (DE HEV) Owners Manual: SCC (smart cruise control) malfunction message
The message (“Check Smart Cruise Control System”) will appear when the vehicle
to vehicle distance control system is not functioning normally.
We recommend have the system checked by an authorized Kia dealer.
CAUTION
Do not install accessories around the sensor and do not replace the bum ...
