Kia Niro: Tire Pressure Monitoring System / TPMS Receiver Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable. |
| 2. |
Remove the glove box. (Refer to Body - "Glove Box Housing") |
| 3. |
Disconnect the blower motor connector (A).
|
| 4. |
Disconnect the body control module (BCM) connector (A).
|
| 5. |
Loosen the body control module bolt and nut.
|
| 6. |
Disconnect the connector and then remove the body control module.
|
| 7. |
Install in the reverse order of removal.
|
| Diagnosis procedure by using diagnostic device |
The main contents of diagnostic method using diagnostic device are as follows:
| 1. |
Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnostic device, and then turn on the self-diagnostic device after key is ON. |
| 2. |
Select the "vehicle model" and "TPMS" on KDS/GDS vehicle selection screen, then select OK. [Vehicle Name Writing Method 1]
[Vehicle Name Writing Method 2]
[Vehicle Name Writing Method 3]
[Wheel Sensor ID Writing Method 1]
[Wheel Sensor ID Writing Method 2]
[Wheel Sensor ID Writing Method 3]
[Wheel Sensor ID Writing Method 4]
|
TPMS Receiver Description and operation
Operation
1.
General Function
•
Auto-learn takes place only once per Ignition cycle.
•
On successfu ...
Steering System
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Battery Sensor Specification
Specifications
Item
Specification
Rated Voltage (V)
12 - 14
Quiescent Current (uA)
175
Pin
2 (B+, LIN)
...
Kia Niro 2017 (DE HEV) Service Manual: Room Lamp Repair procedures
Removal
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tool ...
