Kia Niro: Tire Pressure Monitoring System / TPMS Receiver Description and operation

Operation
1.

General Function

Auto-learn takes place only once per Ignition cycle.

On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring.

Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.

2.

General Conditions to Learn New Sensors:

Receiver must determine that it is confident that sensor is not temporary:

a.

Uses vehicle speed.

b.

Uses confidence reduction of previously learned sensors.

Typical time of driving continuously at over 15.5 mph (25 km/h) to learn a new sensor is up to 20 minutes.

3.

General Conditions to Un-Learn a sensor that is removed :

It takes less than 20 minutes at 15.5 mph (20 - 30 km/h).

Confidence reduction is dependent on time during which vehicle is driven at speed greater than or equal to 12.4 mph (20 - 30 km/h).

TPMS Sensor Repair procedures
Removal 1. Remove the valve core and deflate the tire. 2. Remove the side of the tire bead area from the wheel using tire changing machine . ...

TPMS Receiver Repair procedures
Removal 1. Disconnect the battery negative cable. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3 ...

Other information:

Kia Niro (DE HEV) Owners Manual: Tire replacement
If the tire is worn evenly, a tread wear Indicator (A) will appear as a solid band across the tread. This shows there is less than 1.6 mm (1/16 in.) of tread left on the tire. Replace the tire when this happens. Do not wait for the band to appear across the entire tread before replacing the ...

Kia Niro (DE HEV) Owners Manual: To cancel cruise control, do one of the following
Depress the brake pedal. Shift into N (Neutral) if equipped with an Dual clutch transmission. Press the CANCEL/O button located on the steering wheel. Decrease the vehicle speed lower than the memory speed by approximately 20 km/h (12 mph). Decrease the vehicle speed to less than app ...

© 2016-2024 www.kniro.net