Kia Niro: SRSCM / Side Impact Sensor (SIS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Repair procedures

Removal

Pressure side impact sensor (P-SIS)

1.	Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work.

2.	Remove the front door trim. (Refer to Body (Interior and Exterior) - "Front Door Trim")

3.	Remove the pressure side impact sensor (A).

Loosen the side pressure sensor mounting screw, and remove the sensor (B).

Tightening torque:

2.0 - 3.0 N.m (0.2 - 0.3 kgf.m, 1.5 - 2.2 lb-ft)

Front Gravity side impact sensor (G-SIS)

1.	Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work.

2.	It separates the center pillar trim. (Refer to Body - see "built-in trim")

3.	Remove the side impact sensor connector (A).

Loosen the mounting bolts and remove the side impact sensor (B).

Tightening torque:

8.0 - 10.0 N.m (0.8 - 1.0 kgf.m, 5.9 - 7.3 lb-ft)

Installation

Pressure side impact sensor (P-SIS)

1.	Install in the reverse order of removal.

After replacing the side impact sensors must ensure that the system is operating normally.

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off

•	You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or the POP-NUT may be rotated.

•	Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.

•	The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.

Front Gravity side impact sensor (G-SIS)

1.	Install in the reverse order of removal.

•	You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or the POP-NUT may be rotated.

•	Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.

•	The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.

Side Impact Sensor (SIS) Components and components location

Components ...

Seat Belt Buckle Switch (BS) Description and operation

Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle ...

Other information:

Kia Niro (DE HEV) Owners Manual: Wireless smart phone charging system
A wireless smart phone charging system located in front of the center console. Firmly close all doors, and turn the ignition to ACC or IGN ON. To start wireless charging, place the smart phone equipped with wireless charging function on the wireless charging pad. For best wireless charging r ...

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description 1. To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor or LHS of inside rearview mirror. 2. Back view camera is a sup ...