Kia Niro: LCD Modes / Service Mode
Service in
It calculates and displays when you need a scheduled maintenance service (mileage or days).
If the remaining mileage or time reaches 1,500 km (900 mi.) or 30 days, “Service in” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
Service required
If you do not have your vehicle serviced according to the already inputted service interval, “Service required” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
To reset the service interval to the mileage and days you inputted before:
- Activate the reset mode by pressing the OK button (reset) for more than 5 second,
then press the OK button (reset) again for more than 1 second (Europe).
- Press the OK button (reset) for more than 1 second (Except Europe).
Service in OFF
If the service interval is not set, “Service in OFF” message is displayed on the LCD window.
✽ NOTICE
If any of the following conditions occurs, the mileage and days may be incorrect.
- The battery cable is disconnected.
- The fuse switch is turned off.
- The battery is discharged.
Tire Pressure
This mode displays the pressure status of each tire.
You can change the tire pressure unit in “User settings” mode.
❈ For more details, refer to “User Settings mode” in this chapter. ...
User Settings Mode
On this mode, you can change setting of the doors, lamps, and so on.
WARNING
Do not adjust the User Setting while driving.You may lose your steering control
and cause severe personal injury or a ...
Other information:
Kia Niro (DE HEV) Owners Manual: Engine compartment fuse panel (Battery terminal cover)
Engine room compartment fuse panel
Circuit (PCB Block)
Relay
...
Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Compression Pressure Inspection
If the there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
1.
Warm up and stop the engine.
Allow ...
