Kia Niro: Rear Suspension System / Rear Lower Arm Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Suspension System / Rear Suspension System / Rear Lower Arm Repair procedures

Removal

1.	Disconnect the battery negative cable.

Remove the wheel and tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel nuts when removing the wheel and tire.

Loosen the rear lower arm bolt (A,B), rear shock absorber bolt (C) and stabilizer link bolt (D) and then remove the rear lower arm.

Tightening torque:

(A) 107.9 - 117.7 N·m (11.0 - 12.0 kgf·m, 79.6 - 86.8 lb·ft)

(B) 137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)

(D) 19.6 - 29.4 N·m (2.0 - 3.0 kgf·m, 14.5 - 21.7 lb·ft)

Set up the transmission jack under the lower arm in order to remove the shock absorber in no-load condition.

4.	Install in the reverse order of removal.

5.	Check the wheel alignment. (Refer to Suspension System - "Alignment")

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the rear lower arm for deformation.

3.	Check the coil spring and spring pad for deterioration and deformation.

4.	Check all bolts and nut.

Rear Shock Absorber Repair procedures

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel nuts and tire. Tightening torque: 107.9 - 127.5 N ...

Rear Upper Arm Repair procedures

Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay shoul ...

Kia Niro 2017 (DE HEV) Service Manual: Power Window Motor Repair procedures
Inspection • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Wh ...