Kia Niro: Rear Bumper / Rear Bumper Cover Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the combination lamp cover (A).

2.	Remove the rear combination lamp (A) after loosening the mounting screws.

3.	Remove the waterproof seal (A).

4.	Disconnect the rear combination lamp connector (A).

5.	Loosen the rear bumper upper mounting fastener.

6.	Remove the rear bumper side after loosening the screw and fastener.

7.	Remove the wheel guard mounting clip (A).

8.	Remove the rear bumper side under cover (A). [LH] [RH]

9.	Loosen the mounting bolts.

10.	Disconnect the rear bumper main connector (A).

11.	Remove the rear bumper cover (A).

12.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Rear Bumper Cover Components and components location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Other information:

Kia Niro (DE HEV) Owners Manual: Warning type
If an approaching vehicle detected by sensors, the warning is chime and the warning light will blink on the outside rearview mirror. If the detected vehicle is out of detection range, moving away in the opposite direction or moving slow, the warning is cancelled. The system may no ...

Kia Niro 2017 (DE HEV) Service Manual: Fuel Pressure Sensor (FPS) Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] 50 (0.51, 7.3) 0.3 600 (6.12, 87.0) 2.5 1100 (11.2, 159.5) 4.5 ...