Kia Niro: Power Windows / Power Window Motor Repair procedures

Inspection
  

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

Be careful to store and handle the trim when removing/installing because lubricant and oil can leave a stain on the trim.

Front Power Window Motor

1.

Disconnect the negative (-) battery terminal.

2.

Remove the front door trim.

(Refer to Body - "Front Door Trim")

3.

Disconnect the motor connector (A) from the motor.

4.

Connect the terminal No.2 and No.1 to battery voltage (12V) and check that the motor operates smoothly when connecting the terminals below.

[Safety Window Motor]

5.

Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

[Standard Window Motor]

Rear Power Window Motor

1.

Disconnect the negative (-) battery terminal.

2.

Remove the rear door trim.

(Refer to Body - "Rear Door Trim")

3.

Disconnect the motor connector (A) from the motor.

4.

Connect the motor terminals No.1 and No.2 directly to battery voltage (12V) and check that the motor operates smoothly.

If the operation is abnormal, replace the motor.

Power Window Motor Schematic diagrams
Circuit Diagram ...

Power Window Switch Components and components location
Components Driver Power Window Switch [Driver Power Window Switch (Non-IMS Type)] Connector Pin Information [Connector A] (Driver Safety Power Switch / Auto Down P ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Bumper Cover Repair procedures
Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pie ...

Kia Niro 2017 (DE HEV) Service Manual: Sunroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws. ...

© 2016-2024 www.kniro.net