Inspection |
Diagnosis With KDS/GDS
1. |
The body electrical system can be quickly diagnosed for failed parts by using the vehicle diagnostic system (KDS/GDS). The diagnostic system (KDS/GDS) provides the following information.
|
2. |
Select the 'Car model' and the system to be checked in order to check the vehicle with the tester. |
3. |
Select the 'Power seat module (PSM)' to check the power seat module (PSM). |
4. |
Select the 'Current data' menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the power seat module (PSM) can be checked. |
Seat Control Switch
1. |
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.
|
[Power seat control switch]
(Non-IMS Type) |
(IMS Type) |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front seat outer shield cover. (Refer to Body - "Front Seat Outer Shield Cover") |
3. |
Remove the slide knob (A) and height knob (B).
|
4. |
Remove the power seat control switch (A) after loosening the screws.
|
Installation |
1. |
Install the power seat control switch. |
2. |
Install the slide knob and height knob. |
3. |
Install the front seat outer shield cover. |
4. |
Connect the negative (-) battery terminal. |
Kia Niro 2017 (DE HEV) Service Manual: AVN Remote Controller Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering back cover (A) after loosening the mounti ...
Kia Niro (DE HEV) Owners Manual: Low Tire Pressure Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When one or more of your tires are significantly underinflated.
❈ For more details, refer to “Tire Pressur ...