Kia Niro: Power Door Locks / Power Door Lock Switch Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch Repair procedures

Inspection

[Non-IMS Type]

1.	Check for continuity between the terminals. If there is an abnormality, replace the switch.

[IMS Type]

Diagnosis With KDS/GDS

The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS/GDS).

The diagnostic system (KDS/GDS) provides the following information.

(1)	Self diagnosis : Checks and displays the failure code (DTC)

(2)	Current data : Checks the system input/output data state

(3)	Actuation test : Checks the system operating condition

(4)	Additional function : Other controls such as the system option and zero point

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Body Control Module (BCM)' to check the driver seat or assist door module (DDM/ADM).

4.	Select the "Current Data" menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the driver seat or assist door module (DDM/ADM) can be checked.

5.	To check the power door lock operation by force, select "Actuation test".

Removal

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Be careful to store and handle the trim when removing/installing because lubricant and oil can leave a stain on the trim.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window switch assembly (A) after loosening the mounting screws.

Installation

1.	Install the power window switch assembly.

2.	Install the front door trim after connecting the connector.

3.	Connect the negative (-) battery terminal.

Power Door Lock Module Repair procedures

Inspection • When removing with a flat-tip screwdriver or remover, wrap protective tap ...

Power Door Mirrors

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Front Impact Sensor (FIS) Description and operation
Description • The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indica ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose & nozzle 4. Wiper motor & linkage assembly 5. Washer motor 6. Washer fluid level sensor 7. Washer reservoir tank 8. ...