Kia Niro: Heater / Mode Control Actuator Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Repair procedures

Inspection

1.	Switch "OFF" the ignition.

2.	Disconnect the mode control actuator connector.

Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.

Verify that the mode control actuator operates to the vent mode when connected in reverse.

Mode control actuator [LH]

1. -
2. -
3. Vent mode
4. Sensor ground

5. Feedback signal
6. Sensor (+ 5V)
7. Defrost mode

Mode control actuator [RH]

1. -
2. -
3. Vent mode
4. Sensor ground

5. Feedback signal
6. Sensor (+ 5V)
7. Defrost mode

4.	Connect the mode control actuator connector.

5.	Switch "ON" the ignition.

Check the voltage between terminals 4 and 5.

Specification

Door position	Voltage (V)	Error detecti
Vent	0.3 ± 0.15	Low voltage : 0.1V or less
Defrost	4.7 ± 0.15	High voltage : 4.9V or more

It will feedback the current position of the actuator to controls.

7.	If the measured voltage is not within specification, substitute with a known-good mode control actuator and check for proper operation.

8.	Replace the mode control actuator if it is proved that there is a problem with it.

Replacement

[Driver side]

1.	Disconnect the negative (-) battery terminal.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly".)

3.	Remove the driver side shower duct (A) after loosening the screw.

4.	Install in the reverse order of removal.

[Passenger side]

1.	Disconnect the negative (-) battery terminal.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly")

3.	Disconnect the connector and then remove the mode control actuator (A) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Mode Control Actuator Description and operation

Description Located in the heater unit, the mode control actuator adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control u ...

Auto Defogging Actuator Components and components location

Components Location 1. Auto Defogging Actuator ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: BMS ECU Schematic diagrams
BMS ECU Terminal And Input/Output Signal Connector [B01-VC] (24pin) : High Voltage Battery Cell Voltage Check Connector Pin No. Description Connected to 1 - - 2 ...

Kia Niro 2017 (DE HEV) Service Manual: Resolver Sensor Repair procedures
Inspection Hybrid Drive Motor 1. Inspect the resolver sensor resistance. Item Pin Specification Remarks Resistance (Resolver sensor) 1 - 5 ...