Kia Niro: Engine Control System / Knock Sensor (KS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the intake manifold. (Refer to Engine Mechanical System - “Intanke Manifold”)

Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Knock sensor mounting bolt:

18.6 - 23.5 N·m (1.9 - 2.4 kgf·m, 13.7 - 17.4 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Install in the reverse order of removal.

Knock Sensor (KS) Schematic diagrams

Circuit Diagram Harness Connector ...

Heated Oxygen Sensor (HO2S) Specifications

Specification HO2S [Bank 1/Sensor 1] (Linear) Item Specification Heater Resistance (Ω) 2.5 - 4.0 [20°C(68°F)] HO ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Hood Insulator Pad Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). Be careful not to damage the hood and body. ...

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description • The Hybrid motor system is equipped with two electric motors (HSG, Drive motor). • The traction motor operates to move the vehicle and to provide lower Noise, Vibration, Harshness (NVH) during driving and to achieve fuel ...