Inspection |
1. |
Switch "OFF" the ignition. |
2. |
Disconnect the intake actuator connector. |
3. |
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.
|
4. |
Connect the intake actuator connector. |
5. |
Switch "ON" the ignition. |
6. |
Check the voltage between terminals 5 and 6. Specification
It will feedback the current position of the actuator to controls. |
7. |
If the intake actuator does not operate well, substitute with a known-good intake actuator and check for proper operation. |
8. |
Replace the intake actuator if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the main crash pad assembly. (Refet to Body - "Main Crash Pad Assembly") |
3. |
Disconnect the connector (A) and then remove the intake actuator (B) after loosening the screws.
|
4. |
Install in the reverse order of removal. |
Kia Niro (DE HEV) Owners Manual: Windshield wipers
Operates as follows when the ignition switch is turned ON.
(1) MIST/ : For a single wiping cycle,
move the lever to this (MIST/ ) position
and release it. The wipers will operate continuously if the lever is held in this
position.
(2) OFF / O : Wiper is not in operation
(3) INT / --- : Wipe ...
Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description
The High Voltage Battery System provides the hybrid drive motor, HSG, and electric
A/C compressor with electric energy and also reserves the electric energy generated
during regeneration braking. It consists of the battery pack assembly, BMS ECU,
power relay assembly, ...