Kia Niro: Dual Clutch Transmission Control System / Input Speed Sensor Repair procedures

Removal

1.	Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator Assembly")

Remove the connector from the bracket after disconnecting the connector and then remove the input speed sensor (A).

Tightening torque :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Installation

Install in the reverse order of removal.

Before installing the input speed sensor, check the assembled state of the O-rings (A) and apply gear oil to the surface of O-rings.

Schematic Diagrams ...

Component Location 1. Inhibitor switch 2. Manual control lever ...

Kia Niro 2017 (DE HEV) Service Manual: Engine Coolant Temperature Sensor (ECTS) Schematic diagrams
Circuit Diagram ECTS [Water Temperature Control Assembly] Harness Connector ECTS [EGR Cooler Tube] Harness Connector ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Driver power window switch 2. Assist power window switch 3. Rear power window switch 4. Front window motor 5. Rear window motor ...