Kia Niro: General Information / High voltage shut-off procedures

Kia Niro 2017 (DE HEV) Service Manual / General Information / High voltage shut-off procedures

High Voltage Shut-off Procedures

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to read and follow the “High Voltage Shut-off Procedures” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

High voltage components:

High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.

1.	Turn the ignition switch OFF and disconnect the auxiliary 12V battery negative (-) terminal.

2.	Remove the safety plug cover (A) under the rear seat..

3.	Unfasten the hook (A) to the direction of arrow.

4.	Unfasten the lever (A) to the direction of arrow.

5.	Remove the safety plug (A).

6.	Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged.

Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.

(1)	Remove air cleaner assembly and air duct. (Refer to Engine Mechanical System – “Air Cleaner”)

(2)

Disconnect the inverter power cable (A).

Disconnect the inverter power cable as the procedures below.

(3)

Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.

Less than 30V : High voltage circuit properly shut

More than 30V : Fault on high voltage circuit

If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, there can be serious problems on the high voltage circuit. In this case, check DTC and never touch the high voltage system circuits.

General safety information and caution

Safety Precaution Precautions to take before servicing high voltage system ...

Basic Service Symbols

...

Other information:

Kia Niro (DE HEV) Owners Manual: In case of an emergency while driving
If the engine stalls at a crossroad or crossing • If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you have a flat tire while driving If a tire goes flat while you are driving: 1. Take your foot off ...

Kia Niro 2017 (DE HEV) Service Manual: CVVT & Camshaft Description and operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, ...