Kia Niro: Hybrid Motor System / High voltage shut-off procedures

Kia Niro 2017 (DE HEV) Service Manual / Hybrid Motor System / High voltage shut-off procedures

High Voltage Shut-off Procedures

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to read and follow the “High Voltage Shut-off Procedures” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

High voltage components include:

High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor, etc.

1.	Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.

2.	Remove the safety plug cover (A) under the rear seat.

3.	Unfasten the hook (A) in the direction of arrow.

4.	Unfasten the lever (A) in the direction of arrow.

5.	Remove the safety plug (A).

6.	Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged.

Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.

(1)	Remove air cleaner assembly and air duct. (Refer to Engine Mechanical System – “Air Cleaner”)

(2)

Disconnect the inverter power cable (A).

Disconnect the inverter power cable as shown below.

(3)

Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.

Less than 30V : High voltage circuit properly shut

More than 30V : Fault on high voltage circuit

If voltage over 30V is measured, reconfirm that the safety plug has been removed. If voltage over 30V is measured even though the safety plug has been removed, there can be serious problem with the high voltage circuit. In this case, check DTC and do not touch the high voltage system circuits.

General safety information and caution

Safety Precaution Precautions to take before servicing high voltage system ...

Specifications

Specifications Hybrid Drive Motor Item Specification Type PMSM (Interior Permanent Magnet Synchronous Motor) ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Relay Box (Engine Compartment) Components and components location
Component Location E/R Junction Block Circuit (E/R Junction Block) PCB Block Circuit (PCB Block) ...

Kia Niro (DE HEV) Owners Manual: Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. WARNING - Rear visibility Do not place objects in the rear seat or cargo area which would interfere with your vision through the rear window. WARNING Do not adju ...