Kia Niro: Fuel Delivery System / Fuel Pump Control Module (FPCM) Schematic diagrams

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump Control Module (FPCM) Schematic diagrams

Circuit Diagram

Terminal Information

Terminal Illustration

Terminal Function

Pin No.	Description
1	Fuel Sender (-)
2	Fuel pressure sensor (FPS) signal input
3	Fuel pressure sensor (FPS) ground
4	Ground (-)
5	CAN [Low]
6	Fuel Sender (+)
7	-
8	Fuel Pressure Sensor (FPS) Power [+5V]
9	CAN [High]
10	Battery Power (B+)

Fuel Pump Control Module (FPCM) Description and operation

Description Installed on the right hand side of the fuel tank, the Fuel Pump Control Module (FPCM) controls the DC motor mounted inside the low pressure fuel pump. The module compares ...

Fuel Pump Control Module (FPCM) Repair procedures

Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the rear seat cushion. (Refer t ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replac ...

Kia Niro 2017 (DE HEV) Service Manual: A/C Pressure Transducer Repair procedures
Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminals "1" and “2”. 2. Check if the voltage is within specification. Voltage = 0.00878835 * Pressure + ...