Kia Niro: Front Bumper / Front Bumper Cover Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Loosen the radiator upper cover mounting bolts and clips.

2.	Remove the engine under cover (A).

Separate the front bumper side after loosening the front bumper side screws and clips.

Remove the front bumper by lifting up and pulling out the side of the front bumper.

4.	Disconnect the front bumper main connector (A).

5.	Remove the front bumper cover (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Front Bumper Cover Components and components location

Component Location 1. Front bumper cover ...

Radiator Grille Components and components location

Component Location 1. Radiator Grille ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description The Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the high voltage power circuit between the high voltage batte ...

Kia Niro 2017 (DE HEV) Service Manual: Heater Unit Components and components location
Component Location 1. Heater unit assembly Components [LH] 1. Heater Core Cover 2. Heater Core Assembly 3. PTC Heater 4. Duct Sensor 5. Shower Duct [LH] 6. Evaporator lower case insu ...