Kia Niro: Cylinder Block / Fly Wheel Repair procedures

Removal and Installation

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to shut off the high voltage circuit according to the “High Voltage Shut-off Procedures” before doing any work related with the high voltage system to avoid serious electrical injuries.

1.	Shut off the high voltage circuit. (Refer to Engine Mechanical System - “High Voltage Shut off Procedure”)

2.	Remove the dual clutch transmission. (Refer to Dual Clutch Transmission (DCT) - "Dual Clutch Transmission Assembly")

3.	Remove the engine clutch disk and clutch cover. (Refer to Engine Clutch System - "Clutch Cover and Disk")

Remove the flywheel (A).

Tightening torque :

78.5 - 88.3 N·m (8.0 - 9.0 kgf·m, 57.9 - 65.1 lb·ft)

Always use new flywheel bolts.

5.	Install in the reverse order of removal.

Components 1. Water jacket insert 2. Cylinder block 3. Oil ring 4. Rear oil seal 5. Crankshaft upper bearing 6. Thrust bearing 7. Crankshaft ...

Removal and Installation 1. Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket ...

Kia Niro 2017 (DE HEV) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the KDS/GDS. Specification: Refer to “Wave Form” Removal ...

Kia Niro 2017 (DE HEV) Service Manual: Coolant Repair procedures
Refilling And Bleeding Never remove the cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the reservoir. ...