Inspection |
1. |
TCM ground circuit test : Measure the resistance between TCM and chassis ground. (Inspect the terminal connected to the chassis ground with the back of harness connector as the inspection point of TCM side.)
|
2. |
TCM connector test : Disconnect the TCM connector and visually check the ground terminals on TCM side and harness side for bent pins or poor contact pressure. |
3. |
If problem is not found in Steps 1 and 2, the TCM could be faulty. If so, replace the TCM with a new one, and then check the vehicle again. If the vehicle operates normally then the problem was likely with the TCM. |
4. |
Reinspection of original TCM : Install the original TCM (probably broken) into a known-good vehicle and check the vehicle. If the problem occurs again, replace the original TCM with a new one. If the problem does not recur, this is an intermittent problem and other part may be faulty. |
Removal |
1. |
Disconnect the battery negative (-) cable. |
2. |
Disconnect the TCM connector (A).
|
3. |
Remove the TCM after loosening the nuts (A).
|
Installaion |
1. |
Install in the reverse order of removal.
|
Kia Niro 2017 (DE HEV) Service Manual: Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection
1.
Switch "OFF" the ignition.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure
resistance between the ECTS terminals ...
Kia Niro 2017 (DE HEV) Service Manual: Power Seat Motor Repair procedures
Inspection
Power Seat Motor
1.
Disconnect the connectors for each motor.
[Slide motor
(A)]
[Rear height
motor (B)]
[Front tilt
motor (C)]
[Reclining
motor (D)]
[Lumber support
motor (E)]
...