Kia Niro: Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Inspection

1.	Switch "OFF" the ignition.

2.	Disconnect the OCV connector.

3.	Measure resistance between the OCV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: 9.4 ~ 10.4 Ω [20°C(68°F)]

Removal

[CVVT Oil Control Valve (Exhaust)]

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	OCV extension wiring connector (A).

3.	Release the wiring mounting bracket (B) after loosening the mounting bolt.

Remove the mounting bolt (A), and then remove oil control valve & extension wiring (B) from the engine.

CVVT oil control valve mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

5.	Disconnect the oil control valve (A) from the extension wiring (B).

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply engine oil to the valve O-ring.

1.	Install in the reverse order of removal.

Circuit Diagram Harness Connector OCV [B1/EX] ...

Specification Item Specification Coil Resistance (Ω) 0.52 ± 5 % [20°C(68°F)] Rated Voltage (V) 6 ...

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description Burglar Alarm State [B/A State] B/A State Description DISARM 1) This is the state when "ARM" mode is off. 2) If all doors or hood or tailgate ar ...

Kia Niro 2017 (DE HEV) Service Manual: Heated Oxygen Sensor (HO2S) Repair procedures
Inspection 1. Switch "OFF" the ignition. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. Specification: 2.5 - 4.0Ω [20°C(68°F)] ...