Kia Niro: Audio / Audio Unit Repair procedures

Removal
  

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

Be careful to store and handle the crash pad when removing/installing because lubricant and oil can leave a stain on the trim.

1.

Disconnect the negative (-) battery terminal.

2.

Remove the center fascia upper panal.

(Refer to Body - "Center Fascia Panel")

3.

Remove the audio head unit (A) after loosening the screws.

4.

Remove the audio head unit after disconnecting the connectors and antenna cable (A).

  

When the compact disc is stuck, do not remove with force.

Installation
1.

Connect the audio unit connectors and antenna cable.

2.

Install the audio head unit.

3.

Install the center fascia upper panel.

4.

Connect the negative (-) battery terminal.

  

Make sure the connector are connected in properly.

Check the audio system.

Audio Unit Components and components location
Components [RADIO/CD/MP3] Connector Pin Information No. Connector A Connector B 1 Rear left speaker (+ ...

Speakers Repair procedures
Inspection Troubleshooting of the speakers    When handling the speakers : • D ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Engine 2. Hybrid Drive Motor Assembly 3. Hybrid Starter Generator (HSG) 4. Transaxle 5. High Voltage Battery System Assembly 6. Power Cable ...

Kia Niro (DE HEV) Owners Manual: Blade inspection
✽ NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contamination a ...

© 2016-2025 www.kniro.net