Kia Niro: Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection
1.

Measure the pressure of high pressure line by measuring voltage output between terminals "1" and “2”.

2.

Check if the voltage is within specification.

Voltage = 0.00878835 * Pressure + 0.37081095

3.

If the measured voltage is not wihtin specification, replace the A/C pressure transducer.

Replacement
1.

Disconnect the negative (-) battery terminal.

2.

Recover the refrigerant with a recovery/charging station.

  

If PAG oil mixes into the POE oil of the system, dielectric breakdown may occur due to decreased volumetric resistivity and the A/C compressor may not work.

3.

Disconnect the A/C pressure transducer connector (A).

4.

Remove the A/C pressure transducer (A).

  

Be careful not to bend the liquid & suction pipe.

5.

Install in the reverse order of removal.

  

When installing, replace it with a new O-ring (A).

A/C Pressure Transducer Description and operation
Description A/C pressure transducer measures the pressure in high pressure line and converts it into voltage. Based on the converted voltage, engine ECU controls cooling fan by operat ...

Evaporator Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit&qu ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    Before filling the reservoir tank with water, check the filter ...

Kia Niro (DE HEV) Owners Manual: Outside rearview mirror
Be sure to adjust the mirror angles before driving. Your vehicle is equipped with both left-hand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch. The mirror heads can be folded back to prevent damage during an automatic car wash or when pas ...

© 2016-2024 www.kniro.net