Kia Niro: SRSCM / Side Impact Sensor (SIS) Description and operation
| Description |
| • |
Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH) and two rear SIS which are installed in the rear pillar (LH and RH). |
| • |
Pressure Side Impact Sensor is also called P-SIS because it detects pressure due to collision at its mounting location. |
| • |
Side Impact Sensor is also called A-SIS because it detects acceleration. |
| • |
SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred. |
Front Impact Sensor (FIS) Repair procedures
Removal
1.
Disconnect the battery negative terminal, and wait for at least thirty
seconds before beginning work.
2.
Disconnect the front impa ...
Side Impact Sensor (SIS) Components and components location
Components
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: BMS ECU Schematic diagrams
BMS ECU Terminal And Input/Output
Signal
Connector [B01-VC] (24pin) : High Voltage
Battery Cell Voltage Check Connector
Pin No.
Description
Connected to
1
-
-
2
...
Kia Niro (DE HEV) Owners Manual: Securing a Child Restraint System seat with “Top-tether Anchorage” system
Child restraint system top tether anchorages are located on the back of the rear
seatbacks.
1. Route the Child Restraint System top-tether strap over the seatback. Placing
the top tether strap, please follow the instructions of the Child Restraint System
manufacturer.
2. Connect the top- ...
