Kia Niro: Lighting System / Room Lamp Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Removal

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

1.	Disconnect the negative (-) battery terminal.

2.	Using a screwdriver or remover, separate the room lamp lens (A) from the room lamp.

Remove the room lamp (A) after loosening the screws.

•	When removing the room lamp, be careful of the direction in which the tool is inserted (B).

•	When inserting the tool in the opposite direction, take caution as the room lamp may be damaged.

4.	Remove the room lamp assembly (B) after disconnecting the room lamp connector (A).

Bulb Replacement

1.	Using a screwdriver or remover, separate the room lamp lens (A) from the room lamp.

2.	Disconnect the room lamp bulb (A).

Installation

1.	Connect the room lamp connector.

2.	Install the room lamp.

3.	Install the room lamp lens.

4.	Connect the negative (-) battery terminal.

Turn Signal Lamp Repair procedures

Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A) from the mirror holder ...

Vanity Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the vanity lamp (A) using a flat-tip screwdriver. 3. ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Sunroof Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console and remove the 2 screws holding the overhead console. Disconnect the switch connector and Map lamp connector, and then r ...

Kia Niro 2017 (DE HEV) Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low ...