Kia Niro: Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Replacement
  

When installing the belt, be careful not to damage the retractor.

1.

Remove the rear seat cushion assembly.

(Refer to Rear Seat - "Rear Seat Assembly")

2.

Remove the rear seat belt buckle (A) after loosening the mounting bolt.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.9 - 39.8 lb·ft)

3.

Install in the reverse order of removal.

Rear Seat Belt Buckle Components and components location
Component Location 1. Rear seat belt buckle [RH] 2. Rear seat belt buckle [LH] ...

Roof Trim
...

Other information:

Kia Niro (DE HEV) Owners Manual: Fuel Gauge
■ Type A ■ Type B This gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 9. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On in ...

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Trouble Shooting Ignition System Symptom Suspect area Remedy Vehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module). Ignition coil Inspect ignition coil, or repl ...

© 2016-2024 www.kniro.net