Removal |
When replacing the LKAS switch, check that the symbol mark in the cluster operates normally by pressing the ON/OFF switch.
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or remover, remove the mirror wiring cover (A).
|
3. |
Disconnect the LKAS unit connector (A).
|
4. |
Remove the LKAS unit (B) by pulling out lock pins (A).
|
When pulling out the mounting bracket, be careful not to damage it.
|
Installation |
1. |
Install the LKAS unit. |
2. |
Connect the LKAS unit connector. |
3. |
Install the mirror wiring cover. |
4. |
Connect the negative (-) battery terminal. |
Kia Niro 2017 (DE HEV) Service Manual: Front Seat Shield Outer Cover Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
Kia Niro 2017 (DE HEV) Service Manual: Fuel Pressure Sensor (FPS) Specifications
Specification
Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Vref = 5V]
50 (0.51, 7.3)
0.3
600 (6.12, 87.0)
2.5
1100 (11.2, 159.5)
4.5
...