Kia Niro: Engine Control System / Injector Description and operation
| Description |
The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.
The ECM controls both the feed circuits (high side) to feed voltage to the injectors and the ground circuits (low side) to energize the injectors. Also, the feed for 2 injectors comes from the same driver set. As the ignition coils are paired with cylinders (1-4 and 2-3), the injectors are also set up in pairs.
Injector Specifications
Specification
Item
Specification
Coil Resistance (Ω)
1.425 - 1.575 [20°C(68°F)]
...
Injector Schematic diagrams
Circuit Diagram
Harness Connector
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal
1.
Remove the tire.
2.
Disconnect the wheel speed sensor connector (A).
3.
Loosen the bearing bolts (A) and then remove the hub bearing assembly.
Tightening torque:
88.2 - 10 ...
Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering column upper and lower shrouds after loosening the ...
