Kia Niro: Driveshaft Assembly / Dynamic Damper Components and components location
Kia Niro 2017 (DE HEV) Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and components location
| Components |
|
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ housing |
13. TJ circlip |
TJ Joint Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not
substitut ...
Dynamic Damper Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Mass Air Flow Sensor (MAFS) Repair procedures
Inspection
1.
Visually check the MAFS for the following:
–
Correct mounting direction
–
Any contamination, corrosion or damage on connector
–
Clogged or we ...
Kia Niro 2017 (DE HEV) Service Manual: Engine Control Module (ECM) Schematic diagrams
ECM Terminal And Input/Output
signal
ECM Terminal Function
Connector [A]
Pin No.
Description
Connected to
1
Injector (Cylinder #3) [Low] control
Injector (Cylinder #3)
2
...
© 2016-2024 www.kniro.net
