Kia Niro: Body Control Module (BCM) / Components and components location

Components

Connector Pin Information

No.
Connector A
Connector  B
Connector  C
Connector  D
1
-
Key in switch
Front wiper relay (Low)
-
2
-
Heated handle switch
Auto light sensor (GND)
IGN1
3
Rear left seat belt indicator
-
PAS ON switch indicator
IGN2 (Heated handle power_1)
4
Assist seat belt indicator
-
Heated handle switch indicator
IGN2 (Heated handle power_2)
5
Rear center seat belt indicator
Multifunction light switch
-
Heated handle power
6
Rear right seat belt indicator
-
-
Room lamp
7
-
-
Crash signal
Ground (Power)
8
-
PAS (Option)
Auto light sensor
-
9
Mirror unfolding relay
Key inter lock switch
NTC Sensor
-
10
Rear wiper relay
Sunroof open switch
Headlamp switch (High)
Battery (+)
11
-
PAS ON switch
Rear wiper switch
-
12
-
Multifunction switch (GND)
Front wiper INT volume switch
-
13
Key solenoid
-
Front wiper switch
RPAS Power
14
Foot lamp
-
Fog lamp switch
FPAS Power
15
ATM solenoid
-
Front wiper relay (High)
Ground (Signal)
16
-
-
Auto light sensor (Power)

17
Security indicator
-
Sunroof enable (High)
18
Pocket lamp
-
-
19
Safety power window enable (Low)
C-CAN (High)
-
20
Key hole illumination
C-CAN (Low)
-
21
-
B-CAN (Low)
Front wiper low back up switch
22
-
B-CAN (High)
NTC (GND)
23
Mirror fold relay
-
IGN2
24
-
LIN_Rain sensor
ACC
25

LIN_PAS
Rear wiper washer switch
26
-
Front wiper washer switch
27
-
Blade position (High)
28
Rear defogger switch
Brake switch
29
Rain sensor (Option)

30
-
31
-
32
-

Specifications
Specifications Items Specifications Rated voltage DC 12 V Operating voltage DC 9 - 16 V ...

Schematic diagrams
Circuit Diagram ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Inspection AEB function ON / OFF switch was included to USM (User Setting Menu) and the state of the factory is ON. When the IGN On, maintain ON condition by default. And does not reflect the driver settings when next IGN On. If turned the ESP function Off, the AEB function is t ...

Kia Niro 2017 (DE HEV) Service Manual: AVN Antenna Repair procedures
Removal Roof antenna 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the roof antenna cable and connectors (A). ...

© 2016-2024 www.kniro.net