Kia Niro: Front Door / Front Door Module Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front door trim.

(Refer to Front Door - "Front Door Trim")

2.

Remove the front door outside handle.

(Refer to Front Door - "Front Door Outside Module")

3.

Disconnect the front door main connector (A).

4.

Disconnect the outside rear view mirror connector (A).

5.

Separate the rear door module (A) after loosening the mounting bolts.

Tightening torque :

8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft)

6.

Remove the front door module (A) after disconnecting the front door latch connector (B).

7.

Disconnect the connectors and front door module wiring harness (A).

8.

Remove the front speaker.

(Refer to Body Electrical System - "Speakers")

9.

Remove the front power window motor.

(Refer to Body Electrical System - "Power Window Motor")

10.

Remove the side impact sensor.

(Refer to Restraint - "Side Impact Sensor")

11.

Install in the reverse order of removal.

  

Apply enough grease onto the whole parts.

Make sure that connectors are connected properly and each rod is connected securely.

Make sure that the door locks/unlocks and opens/closes properly.

Front Door Module Components and components location
Component Location 1. Front door module ...

Front Door Outside Handle Components and components location
Component Location 1. Front door outside handle ...

Other information:

Kia Niro (DE HEV) Owners Manual: Suitability of each seating position for ISOFIX Child Restraint Systems according to ECE regulations
IUF = Sutiable for ISOFIX Forward-Facing Child Restraint Systems of universal category approved for use in the mass group. IL = Suitable for particular ISOFIX Child Restraint Systems given in the attached list. These ISOFIX CRS are those of the "specific vehicle", "restricted&q ...

Kia Niro 2017 (DE HEV) Service Manual: Canister Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - "Fuel Tank") 3. Disconnect the vapor tube quick-con ...

© 2016-2024 www.kniro.net